Symbols; Parked Position; Safety Systems - Bosch MUM5X Serie Gebrauchsanleitung

Note: The professional beating whisk
is factory-set so that ingredients are
mixed together perfectly.
Correcting tool adjustment
ATTENTION!
The appliance and tools can be dam-
aged if a wrong tool setting is used.
Never operate a tool that touches
▶
the bowl.
Requirements
¡ The mains plug is not inserted.
¡ The swivel arm is open.
¡ The professional beating whisk is
inserted.
¡ The bowl has been inserted.
Hold the beating whisk at the bot-
1.
tom with one hand and release the
lock nut clockwise using a spanner
wrench.
→ Fig.
4
To change the distance, turn the
2.
tool.
→ Fig.
5
Observe the values in the table:
Setting
Optimum set-
ting
One turn clock-
wise
One turn anti-
clockwise
Press the release button and push
3.
the swivel arm down until it en-
gages.
Check the setting.
4.
Press the release button and raise
5.
the swivel arm until it engages.
Hold the beating whisk at the bot-
6.
tom with one hand and tighten the
lock nut anticlockwise using a
spanner wrench.
Distance
3 mm
1 mm more
1 mm less
Familiarising yourself with your appliance en
5.10 Symbols
You can find an overview of the sym-
bols used on your appliance here.
Symbol Description
Marking on the protective
cover for drive 2.
Attachment marking on
the protective cover for
drive 3.
Position marking on
drive 3.
5.11 Parked position
Your appliance is equipped with an
automatic parked position.
After the appliance has switched off,
the drives will continue moving for a
few seconds until the correct parked
position is reached.
Note: The swivel arm will only open
or close with the inserted tool when
the drive is located in the correct

parked position.

The following causes result in an
incorrect parked position:
¡ The power supply was interrupted
during processing.
¡ A safety system terminated pro-
cessing.
¡ During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip: You can easily adjust an incor-
rect parking position yourself.
→ "Troubleshooting", Page 46
5.12 Safety systems
You can find an overview of your ap-
pliance's safety systems here.
39