Fault - Angelo Po 0G0FA0 Bedien- Und Installationshandbuch

TROUBLESHOOTING
Important
For all requirements contact the agents or
the headquarters of Angelo Po which can
be found in the contacts section of the web-
site http://www.angelopo.com.
The appliance has been tested before being put
into service.
Faults
Smell of gas.
The pilot light
does not ignite.
The pilot light does not ignite.
The pilot light goes out.
Burner control knob is stiff.

FAULT

The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
Occasional leak because
flame has gone out.
Air in pipelines due to long
period out of use.
The thermocouple has not
warmed up enough.
The flame is yellow.
Gas control valve malfunction.
- 11 -
Remedies
Turn off the gas supply tap
and ventilate the room.
Make more attempts
to light the flame.
Make more attempts to light
the flame.
Clean the burner
Important
Contact the after-sales
service
6
IT
GB
DE
FR
ES
English