Changing The Settings During Operation; After Usage - Gastroback DESIGN BBQ ADVANCED SMART Bedienungsanleitung

CHANGING THE SETTINGS DURING OPERATION

After starting a program, the appliance is in program mode and you cannot make
any changes. For changing any settings, you need to cancel the program completely
by touching any program icon or the "manual" button for approx. 4 seconds. The-
reafter, you can select any program or the manual mode. Even after the end of a
program, you need to cancel the program first, before entering new settings. When
using the manual mode, you can change the temperature setting any time you like.
For this, proceed as follows:
1. Touch the appropriate grilling plate icon. When using the appliance in contract
grilling mode with the lid closed, you can only enter the temperature value of
the lower grilling plate that will affect the upper grilling plate as well.
2. Touch the selection buttons "+" and/or "–" until the desired temperature is
shown. Without any entries for more than approx. 5 seconds, the appliance
starts the heating cycle automatically. Alternatively, you can start the cycle imme-
diately by touching the "ok" button.
3. After increasing the temperature: Wait until the new temperature value stops flas-
hing on the display area and the appropriate acoustic signal sounds, indicating
that the set temperature is reached.
4. After decreasing the temperature: If required, leave the lid open until the hea-
ting indicator changes its colour, before placing delicate food onto the grilling
plates. Additionally, you may change from contact grilling (closed lid) to table
top grilling (flat 180° position) and vice versa, any time you like.
• When changing from contact grilling to the table top method (flat 180° posi-
tion), the appliance switches to manual mode automatically. As a default, the
temperature for both grilling plates will be set to 150°C (approx. 300°F), but
can be changed independently for each grilling plate.
• When you close the lid after using the table top method, the appliance cancels
the manual mode automatically. Thereafter, you can select any program or the
manual mode.
CAUTION
juices on this grilling plate into the oil tray first via a heat-resistant plastic or wooden
spatula, before moving up the lid. Otherwise at the back of the appliance, very
hot juices may drip onto your working surface.

AFTER USAGE

If you do not wish to continue your gilling session, switch off the appliance via the
68
– After grilling on the grilling plate of the lid, always push the