Functions - Wellsystem SPA Original-Gebrauchsanweisung

Function Button sequence
1. START/STOP
2. LIGHT
3. COLOR
4. COLLAGEN
5. O (ionised air)
2
6. AROMA
7. Running time
09/2011 1010400-00
5.3

Functions

Description
Switch the device on and off
Interrupt operation:
Briefly press the START/STOP
button
End operation:
Press and hold the START/STOP
button for 3 seconds
Switch the coloured light (LEDs)
on and off
Stop colour or re-start colour
change
Switch the lamps on and off
The running time of the collagen
lamps is shown on the display for
3 seconds.
Switch the ionised air on and off
Switching the AROMA on and off
Set time
The display flashes after activating
the running time button. The run-
ning time can be changed by
pressing the plus or minus buttons
within 3 seconds.
Press and hold the plus or minus
button for 2 seconds in order to
activate the fast mode.
Information
If operation is interrupted then the
time continues to elapse. The display
shows 'Hold'. All of the functions and
the LEDs are switched off.
If the operation is ended then the
device switches into standby mode
and the set running time is displayed.
The coloured light has no influence
on the effect of the collagen lamps'
red light.
The maximum running time for the
collagen lamps is set in the preset-
tings.
If the lamps are switched off during
operation then the running time for
the lamps is stopped. The function
can be continued after switching the
device back on until the collagen
running time expires.
Fragrance is distributed for 30 sec-
onds and then the distribution is
interrupted for 30 seconds. This
sequence repeats for as long as the
function is activated.
The presettings define whether this
function is available to the user or
not.
The running time can only be
changed before the start.
Operating instructions – 21
Operation