Setup Location; Commissioning; Operation And Maintenance - Wellsystem Spa Original-Gebrauchsanweisung

09/2011 1010400-00
2.6.2

Setup location

WARNING!
Risk of overheating due to air flow problems!
Operating faults possible.
– Do not change, obstruct or block the air inflow and
outflow area to the device or make any unauthorized
changes to the device. The manufacturer shall bear no
liability for damage or injuries resulting from such ac-
tions.
Environmental conditions
Optimum ambient temperature: Between 20 °C and 35 °C
Storage temperature: Between -15 °C and +60 °C
The device is not to be used outdoors.
A suitable connector for the power supply must be available, see the technical
data on page 31.
A conversion is required in order to operate the device without problems at
altitudes exceeding 2000 meters above sea level. Please contact the cus-
tomer service department (see page 2) without fail before putting the device
into operation.
2.7

Commissioning

The device is delivered ready for use.
See Assembly / commissioning page 13.
2.8

Operation and maintenance

Error-free operation, maintenance and service are required in order to ensure
that the health and safety of the users is not endangered during operation and
to ensure that the device is in a fault-free operating condition.
Always abide by the information and recommendations given in this operating
manual. You must ensure that the intervals for the inspection, maintenance
and service are complied with. Please ensure that the lamps are replaced
after the specified usage time.
Unauthorized modifications and changes to the device and its control unit are
prohibited. Failure to comply with this voids the operating licence!
Information for the operator
Operating instructions – 9