Storage And Maintenance; Warranty; Support And Repairs - ZAPTEC Pro Installationshandbuch

Check the fuses in the charging station
1
Remove the front cover using the
SmartKey* special tool supplied with
the charging station, and take the front
cover off.
* If the charging station is mounted on a ZAPTEC Column, you must use a SmartKey Column (supplied with the column) in
order to access the charging station.

6. Storage and Maintenance

The product must be stored in a dry place with a stable temperature. The protective cover must always be fitted when the
product is not in use.
The following periodic maintenance is recommended:
Wipe down the charging station with a damp cloth.
•
Make sure there are no foreign objects in the charging connector.
•
Check that the charging station has no physical external damage.
•
In accordance with Norwegian law, annual periodic checks must be carried out on all publicly accessible installations by
qualified personnel. (Ref. NEK400)

7. Warranty

We guarantee that the device is free from material faults and complies with
applicable consumer protection laws and regulations in the country in which the product was purchased
or the consumer resides. Further information about your rights under consumer legislation can be found at
zaptec.com/privacy.

8. Support and Repairs

The installation technician/service partner is always the first line of support in the event of problems with the installation.
ZAPTEC strongly recommends that the installation technician complete the dealer course for ZAPTEC Pro before installing a
ZAPTEC Pro system. In the event of any problems, see the chapter on troubleshooting before contacting us via
zaptec.com/support.
2
Check that the fuses in the fuse window
have not tripped (they should all face
upwards).
3
If any of the fuses have tripped,
remove the fuse cover using the snap
cover and flip the fuses up again. Fit
the fuse cover as in step two and clip
the cover into place.
EN
19