Safety Instructions - ZAPTEC Pro Installationshandbuch

1. Safety instructions

WARNING!
Before using or maintaining this product, it is important to read the following safety
instructions. Failure to follow and implement all the instructions and procedures stipulated in
this installation manual will invalidate the warranty and cause Zaptec Charger AS to waive
all liability and claims for compensation.
! Read through the instructions carefully and familiarise yourself with the equipment before
! This equipment may only be installed, repaired and maintained by qualified personnel.
! All applicable local, regional and national regulations must be followed when installing,
! IDo not use a product which is damaged in any way. See the information in the chapter on
! Only use approved cabling for the installation.
! Do not insert foreign objects into the electric vehicle's charging cable.
! Do not use high-pressure washers to clean the ZAPTEC Pro. Follow the instructions in the
! Do not install in a location which is exposed to direct sunlight.
! Adapters are permissible – A conversion adapter from the EVSE plug must only be used if
! Do not insert measuring pins, wires or anything else into the quick-release connector on the
! Read the warranty at zaptec.com/privacy or contact ZAPTEC Support and request a copy.
4
you start using it.
(NEK400). Repairs must be carried out by ZAPTEC or a pre-approved workshop.
repairing and maintaining the equipment.
Support and Repairs.
chapter on Storage and Maintenance.
specified and approved by the vehicle manufacturer or EVSE producer.
back plate. Voltage tests should be performed directly on the coupling screws or using a
female coupling.