Verify The Installation In The Zaptec Portal - ZAPTEC Pro Installationshandbuch

Verify the installation in the ZAPTEC Portal

Check that all the charging stations have been added to the installation in the ZAPTEC
Portal, as described in the chapter "Prepare for the installation in the ZAPTEC Portal", to
make sure that all the charging stations are present.
Test the charging stations
Perform an RCD test using a testing device with a Type 2 plug. The test must be
•
performed in accordance with the testing device's manual.
Carry out a test using an electric vehicle, test load or Mode 3 test equipment.
•
Handover and ZAPTEC Portal access to the
installation owner
Hand over the user manual, SmartKey and final checklist to the owner.
Add the installation owner/owner group to the installation.
Inform the owner/owner group of the jointly owned property/installation that they
•
must register as a user in the ZAPTEC Portal before they can gain access to the
installation.
Go to Authorisations in the ZAPTEC Portal, Grant authorisation and add the user(s)
•
who are to administer the installation as owner. They will only be visible if they have
registered a user profile in the ZAPTEC Portal.
Show the ZAPTEC Portal dashboard to the owner and give a brief presentation of the
•
functions.
Authorisations in the ZAPTEC Portal
Administrator: Gives access to settings, access control, statistics and power
consumption for the installation.
Service: This is a technical role which gives authorisation to add installations, circuits and
charging stations.
User: All authenticated users of the installation. They will only be able to see their own
power consumption.
16