ZAPTEC Pro Installationshandbuch Seite 15

The charging station
is placed correctly
on the back plate.
There is a gap
between the
charging station and
the back plate.
5
Position the charging station on the back plate
Position the charging station on the back plate and check
that it makes full contact with the back plate. There should be
no gap between the charging station and the back plate.
Switch on the power supply to the installation
Check that the status indicator illuminates green, which means that the system is
•
starting up and performing internal checks.
Check that the status indicator changes from yellow to green after 2-3 minutes.
•
If the charging station illuminates purple, it is being updated.
•
See the chapter on troubleshooting for more information if the status indicator
illuminates a different colour.
Activate the charging station
Download the ZAPTEC App from the App Store / Google Play. Register as a user
•
and log in.
Stand close to the charging station you wish to configure.
•
Enter your PIN code. This is unique to each charging station. This will be stated on the
•
box and the zipped bag, or alternatively can be obtained from the ZAPTEC Portal
cloud service (after the charging station has been added to the installation in the
ZAPTEC Portal)
Go to settings and scan for charging stations. Check that you are connected to the
•
correct charging station. There should be a flashing white light on the status indicator
of the charging station.
Configure the power grid in accordance with the installation, and select the
•
communication method to be used. If 4G LTE-M is used, the charging station will
automatically select the 4G setting as the default.
The charging station is online when you can see a green bar on the screen.
•
This must be done for all the devices in the installation.
•
Troubleshooting: If the charging station does not come online, check that the network
setup is in accordance with the network requirements in the chapter "Internet and
Network Requirements".
i
The portal installation must be set up identically to the electrical installation.
6
Fit the front cover
Ensure that the cover for the status indicator (Z) is correctly
positioned before replacing the front cover again. In order to
replace the front cover, you must first position the cover over
the Type 2 port and then attach it to the charging station.
EN
15