Jenoptik CHM 15k-x Bedienerhandbuch Seite 61

JO-DataClient - Terminal software for CHM15k
This image shows a snapshot of the update process for JO-CloVisCHM.exe.
1,081,344 of a total of 1,379,161 bytes were already transmitted.
During the whole time of the update process (which may last for hours) the reg-
ular operation of the CHM15k is not impaired. Moreover, a temporary shutdown
of the CHM15k as well as of JO-DataClient does not interrupt a running update –
when both components run again, a discontinued update process will be
resumed. Finally, a running update can be cancelled only by pressing the (red)
button "cancel software update".
Only if all data blocks of the update were transmitted successfully, the old pro-
gram file "JO-CloVisCHM.exe" is replaced by the new one. Normally this replace-
ment should take no longer as one minute, so that only for this time interval no
current data telegram are calculated. The successful end of the update process
can be noticed within JO-DataClient by disappearing of the red cancel button
and reappearing of the green start button.
Acceleration of the update:
Default setting for the update block size is 2,048 byte, this amount of update
data will be transmitted following every received telegram. With 30 seconds of
Revision 04, May 2009 61