Maintenance And Lubrication Of The Sliding Table - Robland Z 3200 Betriebsanleitung

Fig.15
Maintenance and lubrication
of the sliding table
It is highly recommended to clean the sliding table once a week, and to remove all sawdust and chips
which gradually slow down the sliding table. From both sides of the sliding table blow out the dust
accumulated between the two sections and on the ball carrier.
This can be done more easily and efficiently when the upper part of the sliding table is slid to the rear,
and must then be repeated with the upper part at the front end.
After all dust has been blown out, a thin oil with a teflon base or plain diesel oil should be sprayed onto
the steel V-liner strips on both the upper and lower part of the sliding table. Never use a thick oil or
grease ! This maintenance job will only take 10 minutes of your time, and will ensure the
machine gives full satisfaction.
15
Z3200 10-V0713 – Deutsch – English