PETZL FALCON ASCENT Bedienungsanleitung Seite 3

5
How to put on and fasten the harness
This harness, designed
for rope ascending
(low attachment point),
must fi t snugly at the
5A.
waist and thighs.
5A. Open up the
leg loops using the
DoubleBack buckles.
Hold the seat harness
by the belt, put your
legs through the belt
and pull it up to your
waist.
5B. The two textile
loops of the ventral
attachment point
must ALWAYS be
joined together with a
locking connector that
is suitable for triaxial
loading (OMNI M37TL
or M37SL, DEMI ROND
P18).
Verify that the
connector is properly
closed and locked.
5C. Securely tighten the
belt by pulling on the
belt straps.
5C.
Roll up the excess
webbing and stow it
under the elastics (see
drawing).
5D. Adjust the leg
loops.
Adjustment and
5D.
suspension test
Your harness must be
adjusted to fi t snugly to
reduce the risk of injury
in case of a fall.
You must move
around and hang in
the harness from each
attachment point to
verify that the harness
provides adequate
comfort for the
intended use and that it
is optimally adjusted.
3
FALCON ASCENT C385020C (290509)
5B.
DoubleBack
Go to
size 2
EN 362