01_General Safety Warnings; 02_Introduction; 03_Freehub Compatibility; 04_Resistance - Elite TURNO Anleitung

EN
Thank you for purchasing TURNO.

01_GENERAL SAFETY WARNINGS

Before using your trainer, carefully read
the warnings listed below for your health
and safety.
1. The appliance is not to be used by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction.
2. Children being supervised not to play
with the appliance.
3. Before beginning a training programme,
undergo a physical examination certifying
good health.
4. Choose a training level compatible with
your physical endurance and the status of
your health.
5. If you feel particularly fatigued or sore
while exercising, stop using the trainer
immediately and consult your doctor.
6. Before training, make sure that the bike
is properly installed on the home trainer.
Bike must be vertical and secured on its
supports, as indicated in the instructions.
Try pushing and pulling the frame of the
bike and the saddle to make sure it's
properly installed. Do not start training if
the bike isn't properly secured.
The above warnings are general and not
exhaustive of all the precautions that
should be taken for the proper and safe
use of the trainer; which is solely the
responsibility of the user.
40
ENGLISH

02_INTRODUCTION

Training with the Turno is a simple and effective way to
improve the performance of riders at all levels.
The design of the Turno is based the principle of the direct
transmission of the athlete's power. The trainer connects
directly to the bicycle chain and a cutting-edge system of
timing belt pulleys, designed by Elite, uniformly transmits
the force applied to the pedals to the resistance unit to
optimise indoor training.
The hometrainer resistance increases with speed; use
higher gearing to work on power or lower gearing to work
on agility and pedal cadence. There is a wide range of
available resistance levels, perfect for beginners, more
experienced cyclists and seasoned pros.
Turno has been designed, developed and produced, after
years of study and testing of professional, amateur and
recreational cyclists (on the road, the trail and the track),
to create a high level indoor trainer to fit specific individual
goals and to test and evaluate performance levels.

03_FREEHUB COMPATIBILITY

Turno is equipped with a freehub body compatible with
9/10/11-speed cassettes by Shimano
other manufacturers that use the Shimano
An accessory freehub body compatible with Campagnolo
9/10/11 speed cassettes is available to replace the
original Shimano compatible body provided on Turno; body
replacement instructions can be found on page 35.
Turno is compatible with bikes with 130 to 135 mm hubs
with 5 mm diameter quick release and with bikes with 12
mm x 142 mm thru-axle hubs.
The following accessories are available:
- boost adapter for bicycles with 148mm thru axle with
12mm diameter.
- adapter for bicycles with 135mm thru axle with 10mm
and 12mm diameter.
If you are unsure about the type of derailleur on your
bicycle, refer to the bicycle documentation or contact your
dealer to ensure compatibility with Turno.

04_RESISTANCE

Pedalling resistance is generated by a fluid technology
braking system for extremely quiet training sessions. Fluid
resistance increases automatically with speed, similar to
(but more focused than) the air resistance experienced on
the road.
The Turno resistance curve as a function of speed is
/ SRAM or by
® ®
Standard.
®
®