Setup Menu: Level 1; General; Accessing The Setup Menu For Process Parameters; Changing Welding Parameters - Fronius TransPocket 4000 CEL Bedienungsanleitung

Setup menu: level 1

General

The digital power sources come with a wealth of expert knowledge already built in. You can
retrieve and use any of the optimised parameters stored in the machine whenever you
wish.
The Setup menu provides simple access to this expert knowledge plus some additional
functions. It enables the parameters to be easily adapted to the various tasks.
Accessing the The mode of operation is explained here with reference to the "MMA welding" process. The
Setup menu for procedure for changing other Process parameters is identical.
Process parame-
ters The available parameters can be set separately for all welding processes that can be se-
lected using the Process button (3). The parameter settings are stored until the respective
set value is changed.
1
2
3
4
5
6
The power source is now in the Setup menu for the "MMA welding" process - the first HCU
(HotStart current) parameter is displayed.
Changing weld-
1
ing parameters
2
Exiting the Setup
menu
Example for the "MMA welding" process
Plug in the mains plug
Set the mains switch (8) to the "I" position
Press the Process button (3) to select the "MMA welding" process
Press and hold the Setup / Store (7) button
Press the Process button (3)
Release the Setup / Store (7) button
Use the Process button (3) to select the desired parameter
Use the adjusting dial (1) to alter the value of this parameter
Press the Setup / Store button (7)
1
IMPORTANT! Any alterations are saved by

exiting the Setup menu.

The Setup menu for the processes "MMA
welding with Cel electrode" and "Special
processes" is the same as the "MMA wel-
ding" process menu.
A complete list of parameters for the "MMA
welding" process can be found in the "Pro-
cess parameters" section.
91