Anti-Stick Function - Fronius TransPocket 4000 CEL Bedienungsanleitung

Settings example: I
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
The welding current (I) in the range (9) can be max. 50% lower than the set welding current
(I ). Above a certain level, the welding current (I) is limited by the set arc-force dynamic.
H
Anti-stick func-
The anti-stick function can be activated and deactivated in "Setup menu: level 2" (see the
tion section headed: "Setup menu: level 2").
As the arc becomes shorter, the welding voltage may drop so far that the rod electrode will
tend to stick. This may also cause the rod electrode to burn out.
Electrode burn-out is prevented by activating the anti-stick function. If the rod electrode be-
gins to stick, the power source immediately switches the welding current off. After the rod
electrode has been detached from the workpiece, the welding process can be continued
without any problems.
(9)
(V)
60
50
40
30
20
10
0
0
50 100 150 200 250 300 350 400 450 (A)
= 250 A, arc-force dynamic = 50
H
Load line for rod electrode
Load line for rod electrode where arc length is increased
Load line for rod electrode where arc length is reduced
Characteristic where "con" parameter is selected (constant welding current)
Characteristic where "0.1 - 20" parameter is selected (drooping characteristic with
adjustable slope)
Characteristic where "P" parameter is selected (constant welding power)
Example of pre-set arc force dynamic where characteristic (5) or (6) is selected
Possible change in the current where characteristic (5) or (6) is selected, as a func-
tion of the welding voltage (arc length)
Operating point where arc length is long
Operating point where welding current (I
Operating point where arc length is short
(8)
(6)
(10)
(2)
(1)
(5)
(3)
(11)
(7)
(4)
I +
I - 50 %
H
H
Dynamik
) is set
H
87