Hotstart Function; Eln Function (Characteristic Selection) - Fronius TransPocket 4000 CEL Bedienungsanleitung

3
4
5
6
7
All parameter set values that have been set by means of the adjusting dial (1) will remain
stored until the next time they are changed. This applies even if the power source was
switched off and on again in the interim.

HotStart function

To obtain optimum welding results, it will sometimes be necessary to adjust the HotStart
function.
Advantages
-
-
-
For details on setting the available parameters, please see the section headed "Setup
menu: level 1".
Function
During the specified hot-current time (Hti), the welding current is increased to a certain val-
ue. This value is 0-100% (HCU) higher than the selected welding current (I
Example: A welding current (I
value of 50% has been selected. During the hot current time (Hti, e.g. 0.5 s), the actual
welding current is 200 A + (50% of 200 A) = 300 A.
Eln function
The Eln function can be configured separately for the processes "MMA welding", "MMA
(characteristic se- welding with Cel electrode" and "Special processes".
lection)
Note! For details on setting the available parameters, please see the section headed "Set-
up menu: level 1".
"con" parameter (constant welding voltage)
If the "con" parameter is set, the welding current will be kept constant, irrespective of the
welding voltage. This results in a vertical characteristic (4).
The "con" parameter is especially suitable for rutile electrodes and basic electrodes, as
well as for arc air gouging. The "con" parameter is therefore also the factory setting when
the "MMA welding" process is selected.
For arc air gouging, set the arc-force dynamic to "100".
"0.1 - 20" parameter (drooping characteristic with adjustable slope)
Parameter "0.1 - 20" is used to set a drooping characteristic (5). The setting range extends
from 0.1 A / V (very steep) to 20 A / V (very flat). Setting a flat characteristic (5) is only ad-
visable for cellulose electrodes.
When setting a flat characteristic (5), set the arc-force dynamic to a higher value.
Press the "Parameter selection" button (2) (indicator on the button must light up)
Set the desired amperage using the adjusting dial (1) (value can be read off from the
left-hand indicator)
Press the "Parameter selection" button (2) (indicator on the button must light up)
Set the desired arc-force dynamic using the adjusting dial (1) (value can be read off
from the left-hand indicator)
Start welding
Improved ignition properties, even when using electrodes with poor ignition properties
Better fusion of the base material in the start-up phase, meaning fewer cold-shut de-
fects
Largely prevents slag inclusions
) of 200 A has been set. For the hot current time (HCU), a
H
).
H
85