Tig Comfort Stop Option - Fronius TransPocket 4000 CEL Bedienungsanleitung

a)
9
After the end of welding, the gas post-flow time required to protect the tungsten electrode
and the welding operation depends on the welding current. Welding current gas post-flow
time
Welding current
50 A
100 A
150 A
200 A
250 A
300 A
350 A
400 A
10
11
12
TIG Comfort Stop IMPORTANT! The "TIG Comfort Stop" option is activated and set by means of the CSS
option parameter. The CSS parameter is located in "Setup menu - level 2".
Carry out welding
To finish welding, lift the TIG gas-valve torch away from the workpiece until the arc
goes out.
After the end of welding, wait for the gas post-flow time to finish according to the
standard values in the table.
Close the gas shut-off valve on the TIG gas-valve torch. All parameter set values set
using the adjusting dial (1) remain stored until the next time they are changed. This
applies even if the power source was switched off and on again in the interim.
b)
Gas post-flow time
6 s
7 s
8 s
9 s
12 s
13 s
14 s
16 s
c)
89