Connections - Fronius TransPocket 4000 CEL Bedienungsanleitung

(11)
(12)

Connections

Front and rear view of TP 4000 CEL / TP 5000 CEL po-
wer source
When using the TR 3000 remote control, always connect the rod electrode cable to the (+)
current socket.
(3)
(4)
(5)
(6)
(7)
Overtemperature indicator
Lights up if the power source overheats (e.g. because the duty cycle has been ex-
ceeded). For more information on this, see the "Troubleshooting" section.
TP 08 indicator
Lights up when a TP 08 remote control is connected to the power source.
Even if the TP 08 remote control has already been disconnected, the TP 08 indi-
cator remains lit. As long as the TP 08 indicator is lit, current and arc-force dynamic
can only be set on the TP 08 remote control.
To restore the current and arc-force dynamic setting option on the power source
and other system add-ons:
1. Disconnect TP 08
2. Switch the power source off and back on again
3. TP 08 indicator does not light up
(5) (6)
(1) (2) (3)
Blanking cover
Blanking cover
Blanking cover (reserved for LocalNet connection)
Blanking cover (reserved for LocalNet connection)
Mains cable with strain relief device
(1) (-) current socket with bayonet
latch for:
- Connecting the rod electrode ca-
ble or grounding cable during ma-
nual metal arc welding (depending
on the type of electrode)
- Current connection of the TIG wel-
ding torch
(2) (+) current socket with bayonet
latch for:
- Connecting the rod electrode ca-
ble and grounding cable during
manual metal arc welding (depen-
(4) (7)
ding on the type of electrode)
- Connecting the grounding cable in
TIG welding
73