Technical Data - Grundfos 384-511 Montage- Und Betriebsanleitung

DMX 226 groups
DMX 226 group M
DMX 24-8
DMX 37-5
DMX 52-8
DMX 60-3
DMX 82-5
DMX 100-8
DMX 130-3
DMX 142-8
DMX 160-5
DMX 224-5
DMX 255-3
DMX 380-3
-
-
-
-
-
5.2.4 Function of a servomotor with analogue
control and service switch
The microprocessor controller is integrated in the
drive housing. The controller positions the drive
based on a guide value (setpoint in mA signal) and
compares the specified setpoint with the actual drive
position (actual value). If the two values differ, the
drive is moved to the position determined by the
setpoint. The actual value is generated by a
potentiometer integrated in the drive.
Any positions can be assigned to 4 (0) mA and 20
mA at any time. The lower and upper current limits (4
(0)/20 mA) are pre-programmed and cannot be
changed. The control direction can also be reversed
using a DIP switch " /inv".
In addition, this servomotor version is equipped with
an "Auto/Manual" service switch and a switch for
adjusting the positioning travel manually.
DMX 226 group L
DMX 67-10
DMX 95-8
DMX 132-10
DMX 152-6
DMX 190-8
DMX 190-10
DMX 199-8
DMX 249-3
DMX 280-6
DMX 280-8
DMX 321-4
DMX 321-6
DMX 460-3.5
DMX 460-6
DMX 315-3
DMX 525-3
DMX 765-3

6. Technical data

1 7
Fig. 1 Servomotor with analogue control
Item Description
1 Programming buttons
2 Alarm output
3 LEDs
4 DIP switch
5 Mains connection terminals
6 Analogue signal connection terminals
7 Manual adjusting switch, service switch
8 Earth terminal
3 4
6
5
8
2
7