Malfunction Table - Dibo SBH-G-D Bedienungsanleitung

E N
M a l F u n C T I o n Ta B l E
MALFUNCTION
Machine does not start
no water pressure
Instable and to weak pressure
Water in product tank
no additions of products
no hot water SBh-D
no hot water SBJ-G
aerator does not turn
SBh-D
SBh-G
Burner does not start
hp pump pulse

Malfunction table

at a possible malfunction one can consult the table mentioned below and if you
obtain on this basis no solution, we advise to contact a DiBo technician and/or
a recognized DiBo representative.
CAUSE
• Electrical supply not connected
• net fuse defect
• Main switch on "0"
• Rest malfunctions
• To few water inlet
• Filter stuffed-up
• air in water supply (leaks in water
supply)
• nozzle or lance stuffed-up or worn-
out.
• pressure regulator defect
• Rest malfunctions
• non return valve in filter defect
• Suction pipe
• Suction filter stuffed-up
• product tank empty
• Spray pressure to high
• Main switch not on position "2"
• Burner switch not on position "1"
• heat resistors defective
• Temperature sensor defective
• Rest malfunctions
• net fuse defect
• Main switch not on position "2"
• Burner switch not on position "1"
• Electrical motor defective
• no fuel
• rest malfunctions
• leak or congestion in supply
conduit
• To much air present
DiBO 58
SOLUTION
• Connect the electrical supply
• Check net fuse
• put main switch on "1"
• Consult an expert
• Repair water inlet
• Clean/replace filter cartridge
• put machine completely without
power! Repair leaks in supply.
• Clean or replace
• Consult an expert
• Consult an expert
• Replace suction filter
• Repair suction pipe
• Clean suction filter
• Refill or replace tank
• lower spray pressure
• put main switch on position "2"
• put burner switch on position "1"
• Consult an expert
• Consult an expert
• Consult an expert
• Check net fuse
• put main switch on position "2"
• put burner switch on position "1"
• Consult an expert
• Refill fuel
• Consult an expert
• Clean/replace/repair
• De-aeration of cleaner