Malfunction Table - Dibo ECN Serie Gebrauchsanweisung

7. Malfunction table

At a possible malfunction one can consult the table mentioned below and if you obtain on this basis no solution, we
advise to contact a diBO technician and/or a recognized DiBO representative.
Malfunction
Machine does not start
No water pressure
Instable and to weak pressure
Water in product tank
No additions of products
Cause
Electrical supply not connected
Net fuse defect
Main switch on "0"
Rest malfunctions
To few water inlet
Filter stuffed-up
Air in water supply (leaks in water
supply)
Nozzle or lance stuffed-up or worn-
out.
Pressure regulator defect
Rest malfunctions
Non return valve in fi lter defect
Suction pipe
Suction fi lter stuffed-up
Product tank empty
Spray pressure to high
DiBO n.v. 43
Solution
Connect the electrical supply
Check net fuse
Put main switch on "1"
Consult an expert
Repair water inlet
Clean/replace fi lter cartridge
Put machine completely without
power! Repair leaks in supply.
Clean or replace
Consult an expert
Consult an expert
Replace suction fi lter
Repair suction pipe
Clean suction fi lter
Refi ll or replace tank
Lower spray pressure