KCI V.A.C. SIMPLACE DRESSING Anwendungsanweisungen Seite 22

4. Place small end of the V.A.C.
V.A.C. Drape / 3M™ Tegaderm™ Dressing at wound site (fig. 24) and position the larger
®
end of the V.A.C.
®
5. Using additional V.A.C.
fig. 26 - 3M™ Tegaderm™ Dressing application shown). Apply V.A.C.
Tegaderm™ Dressing as described in the V.A.C. drape Application section or 3m™
Tegaderm™ dressing Application section.
6. Pinch V.A.C. Drape / 3M™ Tegaderm™ Dressing and carefully cut an approximately 2.5 cm
®
hole through the V.A.C.
should be large enough to allow for removal of fluid and/or exudate. It is not necessary to
cut into the foam.
NoTE: Cut a hole rather than a slit, as a slit may self-seal during therapy.
7. Apply SensaT.R.A.C.™ Pad (fig. 28) as described in the SensaT.r.A.C.™ pad Application
section.
8. Connect SensaT.R.A.C.™ Pad to the V.A.C.
the V.A.C. Therapy Application section.
®
Sprial GranuFoam™ bridge over the hole in the
®
Sprial GranuFoam™ bridge where the SensaT.R.A.C.™ Pad will be placed.
Drape / 3M™ Tegaderm™ Dressing, cover the bridge (fig. 25,
®
Drape / 3M™ Tegaderm™ Dressing (not a slit) (fig. 27). The hole
®
Therapy Unit and apply therapy as described in
®
22
Drape or 3M™
®