Yamaha RX-V3900 Bedienungsanleitung Seite 113

■ Selecting the input source of Zone 2 or
Zone 3
Rotate the CINPUT selector (or set the
operation mode selector to FAMP and then
press one of the input selector buttons (3)).
• Select "TUNER" as the input source to use the FM/AM
tuning features (page 48) in the selected zone.
• Select "DOCK" as the input source to use the iPod
features (page 56) or Bluetooth features (page 54) in
the selected zone.
• Select "USB/NET" as the input source to use the USB
features (page 59) or network features (page 59) in the
selected zone.
Note
The input sources are shared across all zones.
■ Adjusting the volume level of Zone 2 or
Zone 3
Rotate P VOLUME (or press J VOLUME +/–) .
y
Press L MUTE on the remote control to mute the sound output
to the selected zone.
Note
When you use the external amplifiers in Zone 2 or Zone 3,
J VOLUME +/– can be used only when "Zone2 Volume" or
"Zone3 Volume" is set to "Variable" (page 85).
■ Adjusting the front speaker balance of
Zone 2 or Zone 3
Press DTONE CONTROL repeatedly to select
"BALANCE" and then rotate the MPROGRAM
selector for adjustment.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Press DTONE CONTROL repeatedly to select
the high-frequency response (TREBLE) or the
low-frequency response (BASS) and then rotate
the MPROGRAM selector for adjustment.
Control range: -10.0 dB to +10.0 dB
■ Setting the sleep timer for Zone 2 or
Zone 3
Use this feature to turn of the desired zone after a certain
amount of time.
Set the operation mode to FAMP and then press
CSLEEP repeatedly to set the amount of time.
The sleep timer setting changes as shown below.
120min.
OFF 30min.
■ Using the zone OSD
You can display the FM/AM radio in the video monitor
connected to the ZONE VIDEO jacks. You can also
browse music contents (such as iPod contents) by using
the zone OSD.
1
Set the operation mode selector to FAMP
and then press the desired input selector
button (3).
2
Press KDISPLAY to display the menu
screen on the zone OSD.
3
Use 9k / n / l / h and 9ENTER to
navigate the menu on the zone OSD.
Notes
• The menu displayed in the zone OSD appears in English
even if Japanese or Russian is selected.
• There are some characters that cannot be displayed in the
front panel display or in the OSD of this unit. Those
characters are replaced with underscores "_".
y
• You can select the zone(s) of which the operational status
is displayed (page 86).
• You can operate the zone OSD in the same way as GUI
operations.
Using multi-zone configuration
90min.
60min.
109
En