Leica DMI3000B Bedienungsanleitung Seite 96

8. Operation
Set the stops via
fi xed function buttons on stand
Leica Application Suite (LAS) Software
Summary of pictograms
lower focus stop not set
lower focus stop set
focus position not set
focus position set
Going to the stops
Go to the lower stop by pressing and holding the
Z button.
↓
Go to the focus position by pressing and holding
the Z ↑ button.
These functions can be assigned to variable
function buttons on the stand or SmartMove, or
they can be controlled via software.
Go to stops via
fi xed function buttons on stand
variable function buttons on stand and
SmartMove
Leica Application Suite (LAS) Software
Note:
When going to the stops with the Z
buttons, hold the button until the stop has been
reached.
96
Setting the step increments
It is possible to toggle between Fine and Coarse
step increments.
The Fine value varies to suit the current objective. Suit-
able values have been predefi ned. The assignments
can be changed with the Leica Application Suite (LAS).
When selecting Coarse, the positioning speed is
the same for all objectives. Coarse corresponds
to the maximum speed.
The assignment of a specifi c step increment to
an objective not only applies to the Z drive, but
also to the step increments assigned to the stage
when Precise (→ p. 102) is selected.
Switch between Fine and Coarse via
variable function buttons on stand and
SmartMove
Leica Application Suite (LAS) Software
Only for DMI6000 B with AFC (Adaptive Focus
Control)
AFC actively holds a pre-defi ned focus position
over time. This feature is especially useful, if
e.g. during a time-lapse experiment at 37°C the
climate chamber has to be opened and a drop of
the temperature may occur.
Activate the AFC function, focus on your speci-
men either with the hand wheel on the micro-
scope stand or at the SmartMove and store the
current focus position as hold position.
and Z
↑ ↓
AFC can be controlled either by.
• Variable function keys at the stand or SmartMove
• STP6000
• Software (Leica LASAF)
Note: