The Timer; Setting/Changing The Time; Semi-Automatic And Fully Automatic Operation - hanseatic 2013C(G)3.334eETsPrDpHbJX Gebrauchsanleitung

The timer

Your oven is equipped with an electronic clock
that can also be used as a timer to switch the
oven on and off.
NOTICE
Quickly set the clock. If you do not touch a
button for 5 seconds, the operation shall be
cancelled. In such a case, press the MENU
button (17) again for about 3 seconds and
start again.

Setting/changing the time

Setting the time
When being used for the first time or after a
power cut, you must set the clock otherwise
the oven will not operate. The display will
then flash "AUTO" and the time (first "0·00
).
1. Press the MENU button until only the
dot between the hour and minute display
flashes.
2. Use the arrow buttons "<" and ">" to set
the time.
Shortly after the last keystroke, an audible
alarm sounds and the dot between the
hour and minute display stops flashing.
The time is now saved.
To quickly go forwards/backwards,
hold the corresponding button down.
The timer
Changing the time
Requirements: The timer must not be in
semi-automatic or fully automatic mode, and
the timer must not be active.
1. Simultaneously press the arrow keys until
the dot between the hour and minute dis-
play flashes.
2. Use the arrow buttons "<" and ">" to set
the time.
Shortly after the last keystroke, an audible
alarm sounds and the dot between the
hour and minute display stops flashing.
The time is now saved.
Semi-automatic and fully
automatic operation
WARNING
There is an increased risk of fi re in auto-
matic mode!
Please make sure to inform all mem-
■
bers of the household so that they do
not put anything in the oven.
Monitor the oven in order to prevent
■
spills and burning.
Take special care when roasting: Fat,
■
oil and alcohol can ignite.
Never leave anything to grill unat-
■
tended!
The timer does not control the switch-
■
ing on and off of the hob.
After use, set the function selector
■
and the temperature controller to
»0«.
All settings will be deleted in the case
■
of a power failure.
– You can pre-programme up to 23 hours
and 59 minutes in advance.
– Any programming will be deleted in the
case of a power failure.
The correctly set time is a prerequisite.
Page EN-25