Getting Started; Removing Transport Locks - hanseatic 2013C(G)3.334eETsPrDpHbJX Gebrauchsanleitung

3. Insert the hob plug into the socket on the
top of the cooker. The plug is coded. Po-
larity reversal is therefore not possible. y
4. Screw the protective earth cable for the
hob firmly to the oven's protective earth
contact point.
5. Ensure that all connections comply with
VDE 0701.
6. Now push the oven back into the built-in
cabinet completely in a centred position.
The mains connection must not be
kinked, pinched or otherwise damaged.
(h)
(h)
(h)
7. Screw the accompanying four screws (h)
through the holes in the sides of the oven
and into the metal rails affixed to the sides
of the built-in cabinet.
Fitting and installation

Getting started

1. Remove all transport safety devices
(cardboard strips, etc.) and all adhesive
strips from the oven.
2. Turn all the cooker's dials to "0".
3. Switch on or screw in the fuses for the
cooker's electrical circuit.
4. Briefly switch on the cooking zones and
oven, and check that they are functioning
properly.

Removing transport locks

• If you have not already done so, remove
any plastic strips from the sides of the
baking sheets.
• Remove all protective films.
Pre-cleaning the oven
The oven must be pre-cleaned to remove all
grease and oil residues from the manufactur-
ing process, as well as tough dust deposits
left over from storage and transportation. This
not only helps protect your health but also en-
sures delicious cakes and roasts.
1. In order to do so, operate the oven for
approximately 60 minutes at a convec-
tion heat of 250 °C. Leave the oven rack,
baking tray and dripping pan in the oven
when doing so.
2. Let all parts dry completely afterwards.
3. Wash the oven rack, baking tray, dripping
pan and cooking compartment with clean
water. Then dry everything off.
To use the appliance see page EN-14.
(h)
Page EN-33