hanseatic 2013C(G)3.334eETsPrDpHbJX Gebrauchsanleitung Seite 69

3. Carefully removed the metal grid.
4. The top pane b is fixed in the grid plate
by three small rubber holders a. Do not
lose these rubber holders.
5. Remove the upper pane b from the
mounts below the hinges and carefully
set it down.
6. Remove the middle pane c and place it
down gently. Be sure not to damage the
rubber seals on the side.
7. Remove the lower pane d and place
it down gently. Ensure that you do not
damage the side rubber seals here as
well.
There are also two rubber holders on
this pane e – do not lose these either.
8. Clean all panes b, c and d with warm
clean water.
9. Dry the panes thoroughly.
10. Slide the bottom pane d into the lowest
position of the holder on the hinge.
11. Make sure that both side rubber seals
and both rubber holders e are positioned
correctly.
12. Slide the middle pane c back into the
holder. Make sure that the side rubber
seals are positioned correctly.
13. Re-insert the inner pane b again.
Cleaning the oven
14. Put the three rubber holders a back on
the top edge of the pane b.
15. Put the grid plate back on top of the door
a
– it only fits in one direction.
16. Firmly press the grid plate onto the door
and tighten it with the two screws.
b
17. Replace the oven door (see „Replacing
the oven door on its hinges" on page
c
EN-22).
d
e
f
e
Page EN-23