The Timer; Setting/Changing The Time; Semi-Automatic And Fully Automatic Operation - hanseatic 2013C(G)3.334eETsDpHbB Gebrauchsanleitung

The timer

All steps regarding the timer must be
quickly carried out one after the other.
The process stops if there is a pause longer
than 5 seconds.

Setting/changing the time

Setting the time
During initial commissioning or after a power
failure, the display "0: 0 0" flashes. This indi-
cates that the time must be set.
1. Press the "MENU" button once.
display shows the symbol " ", the dot un-
derneath flashes.
2. Set the time using the arrow buttons "<"
or ">".
Shortly after the last keystroke, the dot
stops flashing. The time is now saved.
To quickly go forwards/backwards,
hold the corresponding button down.
Changing the time
This is necessary e.g. when changing to and
from summer time.
Requirements:
– The timer switch must not be in automatic
mode and
– the countdown timer must not be active.
1. Press the two arrow keys "<" and ">" si-
multaneously.
The dot beneath the symbol " " flashes.
2. Set the time using the arrow buttons "<"
and ">".
Semi-automatic and fully
automatic operation
WARNING
Please ensure that you always observe
the following when using the automat-
ic timer:
Please make sure to inform all mem-
■
bers of the household so that they do
not put anything in the oven.
Monitor the oven in order to prevent
■
spills and burning.
Take special care when roasting: Fat,
■
oil and alcohol can ignite.
Never leave anything to grill unat-
■
tended when using the timer!
The timer does not control the switch-
■
ing on and off of the hob.
The
After use, set the function selector
■
and the temperature controller to
»0«.
All settings will be deleted in the case
■
of a power failure.
– You can pre-programme up to 23 hours
and 59 minutes in advance.
– Any programming will be deleted in the
case of a power failure.
The correctly set time is a prerequisite.
Page EN-25
The timer