Connecting To A Network With A Fixed Ip Address - Sartorius PMA.Vision VIS1Y Installationsanleitung

If not, go into the submenu "DHCP."
t
Select "On."
t
Confirm with the l button.
t
The DHCP mode is now enabled.
y
When you switch on the scale, the scale is automatically
assigned an IP address by the DHCP server.
Check the network connection (see Chapter 4.3,
t
page 10).
4.2 Connecting to a Network with a Fixed
IP Address
The following settings must be made to connect the scale to
a network with fixed IP addresses:
4.2.1 Configuring Network on a PC
Open the Network and Sharing Center on your Windows
t
PC: Start -> Control Panel -> Network and Sharing Center
Open the LAN connection (1).
t
2
Call up the properties (2) of the LAN connection.
t
1
Select the entry "Internet Protocol Version 4" (3) from the
t
list.
Open the properties (4).
t
English
Installation Instructions VIS1Y
3
4
9