Testing The Network Connection - Sartorius PMA.Vision VIS1Y Installationsanleitung

Select "Use the following IP address" (5).
t
Enter the IP address of the network connection (6).
t
Confirm your entry with "OK" and close each of the
t
following windows with "OK."
4.2.2 Configuring Network on the Scale
Press the "i" button to call up the "Settings" menu.
t
Go into the submenu "Ethernet."
t
Go into the submenu "DHCP."
t
Select "Off."
t
Confirm with the l button.
t
The DHCP mode is now turned off.
y
10 Installation Instructions VIS1Y
Go into the submenu "IP (xxxxxxx)."
t
5
6
Select "t" to enter a new IP address.
t
Enter a new IP address using the input box.
t
Make sure:
− to use an IP address from the same address space as
the Windows PC (Subnet Mask).
− not to use the same IP address as the Windows PC.
Confirm the entry with the l button and exit the Settings
t
menu.
The settings may also have to be configured in the submenu
"Subnet Mask" and "Gateway."
Restart the scale.
t
Check the network connection (see Chapter 4.3, page 10).
t
4.3

Testing the Network Connection

The IP address and device ID can always be found in the
submenu "Device Information."
Press the "i" button to call up the "Settings" menu.
t
Go into the submenu "Device Information."
t