Sartorius PMA.Vision VIS1Y Installationsanleitung Seite 11

If the IP address of the scale changes, e.g., after the DHCP
server allocates a new address, an info message notifies the
user of the change:
Confirm this message with the l button.
t
4.3.1 "Ping" Command
To check whether the network connection is working properly,
send a "ping command" to the scale.
In the input area of the start menu, enter the command
t
"cmd."
Enter the command "ping" in the Windows command
t
console followed by a space and the IP address of the
scale.
Confirm the entry with [Enter].
t
The following figure illustrates what successful detection of
the scale looks like.
If the network connection does not work, contact your
t
administrator.
4.3.2 Access via UPnP (Universal Plug and Play)
The UPnP protocol allows you to find the scale without
knowing its IP address on the network.
The following requirements must be fulfilled:
− Windows PC (XP SP2 and higher) with enabled UPnP
on the same network. (To enable UPnP, see the
documentation for the installed operating system.)
− Support and activation of the UPnP Protocol in the router.
Open the network devices page in the "Explorer."
t
In addition to other UPnP devices, all of the PMA.Vision scales
located on the network are listed under "Other Devices:"
Call up the properties of PMA.Vision "PAINT" by clicking
t
with the right mouse button.
All of the important information about the scale is shown
here.
The device side of the scale can be called up directly in the
web browser by double-clicking on [PMA.Vision "PAINT"].
Installation Instructions VIS1Y
English
11