Connecting To A Network With A Fixed Ip Address - Sartorius PMA.Vision Installationsanleitung

t
If not, go into the submenu "DHCP".
t
Select "On".
t
Confirm with the "i" key.
y
The DHCP mode is now enabled.
When you switch on the scale, the scale is automatically
assigned an IP address by the DHCP server.
t
Check the network connection (see Kapitel 4.3,
Seite 9).
4.2 Connecting to a Network with a Fixed
IP Address
The following settings must be made to connect the scale to
a network with fixed IP addresses:
4.2.1 Configuring Network on a PC
t
Open the Network and Sharing Center on your Windows
PC:
Start -> Control Panel -> Network and Sharing Center
t
Open the LAN connection (1).
8 Installation Instructions VIS1X
2
t
Call up the properties (2) of the Local Area Connection.
1
t
Select the entry "Internet Protocol Version 4" (3) from
the list.
t
Open the properties (4).
3
4