Assembly - AsViva E3 Benutzerhandbuch

:

ASSEMBLY

NOTE:
Before assembling make sure that you will have enough space around the item.
Use the present tooling for assembling
Before assembling please check whether all needed parts are available (at the above
of this instruction sheet you will find an explosion drawing with all single parts (marked
with numbers) which this item consists of.
Step 1
:
Remove the pre-lock board (C) and two bolts (B) at the front end of the main frame assembly (1) and
throw them away. Follow-up installation steps are not needed.
As shown in the figure, turn the upper column assembly (44) in the direction of arrow until the upper
column assembly (44) is close to the main frame assembly (1).
One person holds the upper column assembly (44) and the other person connects the signal line (A1-
A2) after the connection is completed.
The terminal is inserted into a large sheet metal hole on the main frame assembly (1) to avoid over-
whelming the signal line.
As shown in the figure, the sheet metal on the upper column assembly (44) is clamped into the main
frame assembly (44) which is pre-locked
45