AsViva E3 Benutzerhandbuch Seite 46

ASSEMBLY
Step 2
As shown in the figure, the main frame assembly (1) is padded with packing material (A), and the
screw (33), (34) which is pre-locked on the connecting pipe assembly of the left and right front foot
tubes and the upper screw (21) of the main frame assembly (1) are put on the side and back for as-
sembly.
The right front foot connecting pipe assembly (3) is inserted into the square pipe corresponding to the
main frame assembly (1) and locked with three M8*20 internal hexagonal screws (33) and eight
elastic gaskets (34).
The other side is assembled in the same way.
Take the packing material (A) padded under the main frame assembly (1). Cover the front cover (40)
on the square pipe at the front end of the main frame assembly (1).
Lock it with two 4.2*19 cross groove disc head screws (21).
46