AsViva E3 Benutzerhandbuch Seite 56

COMPUTER
NOTE:
① During the body fat measurement, place both your palms on the contact pads. The test result
are: FAT%, BMR(Basal Metabolic Rate), BMI(Body Mass Index), BODY and body
shape.(See fig 40)
c m
fig 39
FAT%: The total body fat in our body measured by
BMR Basal Metabolic Rate (metabolism) is the energy (measured in calories) expended by :
the body at rest to maintain normal bodily function.
BMI: means Body Mass Index, which is used for body shape building
② During the body fat measurement, if your palms do not contact the pulse sensor well, the
computer cannot receive any signal and it will display ERROR2. Press START/STOP to try
again.
③ During the test, you cannot exit the test when press any button. After the test finish, press(or
rotate) UP, DOWN button to exit the body fat measurement program and switch to other
program.
④ Comparison sheet of Body fat and Obese
3. Pulse Recovery Test
The pulse recovery test is to compare your heart rate before and after exercise. It is target to
determine your heart strength via the measuring. Please do the test as below:
A. Both your hands hold the pulse sensor or via wireless transmitter belt to test the pulse(if
applicable), the computer will display your current pulse value.
B. Press RECOVERY to enter the pulse recovery test and the computer program will enter the stop
status.(See fig 41)
C. Keep pulse detecting.
D. Time will count down from 60 seconds to 0 second.
E. When time reaches 0, the test result (F1-F6) appears on the display.
F1=Excellent F2=Good F3=Fair F4=below average F5= No Good F6= Poor(See fig 42)
F. If the computer does not detect your current heart rate first, pressing RECOVERY will not
enter into pulse recovery test. During the pulse recovery test, press RECOVERY to exit the test
and return to the stop status.
PULSE
TIME
4. Pulse Measurement
Please place both your palms on the contact pads and the computer will show your current heart
beat rate in beats per minute (BPM) on the LCD after 3~4 seconds. During the measurement, heart
icon will flash with simulative ECG showing.
Remark: During the process of pulse measurement, because of the contact jamming, the
measurement value may not be stable when start, then it will return to normal level. The
measurement value cannot be regarded as the basis of medical treatment.
NOTE: If the computer is also equipped with wireless heart rate measuring via the transmitter
belt, and with hand pulse function, the hand-measurement-signal-detecting is preferred.
56
ST AR T
ST OP
fig 41
%
ST OP
BMR BMI BOD Y
fig 40
percentage.
fig 42
ST