AsViva E3 Benutzerhandbuch Seite 49

ASSEMBLY
Step 6
As shown in the figure, three screws (21) which are pre-locked on the instrument tube assembly
(44) are removed first. Then, the instrument back cover (49) and the instrument front cover
(48) are fixed on the instrument tube assembly (44) with three self-tapping screws (21) with
4.2*19 cross groove disk head.
Step 7
As shown in the figure, remove four M8*45 hexagonal head screws and four M8 anti-loosening nuts
that are pre-locked on the left and right hand rocker tube (72) (73).
Then two shaker caps (75) are inserted into the left and right shaker caps (72) (73).
Insert the left handshake tube (72) into the left handshake tube assembly circular tube, and lock it with
two M8*45 hexagonal head screws and two M8 anti-loosening nuts (pay attention to the direction of the
head of the screw).
Finally, put down the shaker cover (75). The assembly steps on the other side are the
same.
49