Wet, Packed Snow; Cleaning; Maintenance; Preparation - Stiga ST 1131 E Gebrauchsanweisung

(Translation of the Original Instructions)

7 6 2 Wet, packed snow

Chop packed snow using a spade or similar. Then
push the snow thrower slowly forward. Never hoe
with the snow thrower. Do not attempt to break up
compact snow with the snow thrower as this could
irreparably damage the machine.
7 7

CLEANING

The snow thrower must never be rinsed
with water. Risk of damage to the elec-
trical system and risk of electric shocks
Always clean the machine after use. To clean
the machine adhere to the instructions provided
below:
Stop the motor.
2. Disconnect the electric cable from the snow
thrower and the property's power socket.
3. Clean the inside and outside of the snow
thrower with a suitable brush.
• 4. Check that there are no damaged or loose
parts. Repair/ replace parts if necessary.

8 MAINTENANCE

8 1

PREPARATION

All service and all maintenance checks must be
carried con alimentazione elettrica disinserita.
Unplug the machine
8 2

Maintenance table

Intervention
Always check that the electrical
devices are intact and in good
working order.
Check that the auger turns freely.
Check that all fasteners are
securely tightened. Tighten if
necessary.
Use silicone spray on the auger to
stop it icing up.
Check that the starter switch
can only be activated with the
starter switch locking device (1:B)
disengaged.
General cleaning
ENGLISH
This manual provides all the necessary infor-
mation to run the machine and for correct basic
maintenance operations which can be performed
by the user. Any regulations and maintenance
operations not described herein must be carried
out by your Dealer or Authorized Service Centre,
which have the necessary knowledge and equip-
ment to ensure that the work is carried out correct-
ly, maintaining the correct degree of safety and the
original operating conditions of the machine.
Authorized service workshops carry out guar-
anteed repairs and maintenance. Always use
genuine spare parts.
Frequency
Before each
use
Before each
use
Before each
use
Before each
use
Before each
use
after each
use

9 ASSISTANCE AND REPAIRS

Before performing any servicing opera-
tions:
a Place the machine on a flat surface.
b Take the plug out of the socket
Genuine GGP spare parts and accesso-
ries have been designed specifically for
GGP machines Please remember that
non-genuine spare parts and accesso-
ries have not been verified or approved
by GGP
The use of non-genuine spare parts
and accessories could adversely af-
fect machine operation and safety GGP
shall decline all liability in the event of
injuries or damages caused by such
parts
Genuine spare parts are supplied by
authorized assistance workshops and
dealers
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
safety device inspection
EN
11