Before Starting; Safety Checks; General Safety Check And Auger Operation; Start-Up / Operation - Stiga ST 1131 E Gebrauchsanweisung

EN
Always wear protective goggles or a
visor during use, maintenance and ser-
vice
7 2

BEFORE STARTING

The connection cable and its plugs
must be fault free and approved for out-
door use
The connection cable may only be con-
nected to power sockets equipped with
an earth leakage circuit breaker with a
trip current of max 30 mA
The connection cable must be sus-
pended on the cable support. Otherwise
there is a risk of damage alongside the
plug which is potentially life-threatening.
If the connector cable is damaged, it
must be replaced with a special cable or
assembly, available from the manufac-
turer or the technical assistance service
Using an extension flex, connect the snow thrower
to a power socket in the building:
• Insert the extension flex into the special sup-
port (1:E) and connect the plug (1:D).
7 3

SAFETY CHECKS

When trying out the machine, check that the
results of the safety checks correspond with the
indications provided in the following tables.
Always carry out the safety checks be-
fore use
If any of the results fails to match the
indications provided in the following
table, do not use the machine! Take it
to a service centre to be checked and
repaired if necessary
7 3 1 General safety check and auger oper-
ation
Object
Electrical cables.
Press the starter
switch
Release the starter
switch
10
Result
All insulation intact.
No mechanical damage.
The motor starts and the
auger starts to turn.
No abnormal vibrations.
No abnormal sound.
The motor and the auger
stop immediately.
ENGLISH
7 4

START-UP / OPERATION

Never aim the snow at bystanders
Always stop the motor before unclog-
ging
Always wear eye protection when oper-
ating the snow thrower.
If the auger is blocked, never try to
keep the motor engaged for more than
20 seconds. Extensive engagement will
damage the motor
7 4 1 Snow clearing.
Motor and auger starting
1 Lean the snow thrower back slightly so that
the auger is raised a little above the ground
2 Press and hold the starter switch locking
device (1:B).
3 Activate the starter switch (1:C)
4 Release the starter switch locking device,
lower the auger to the ground and start to
clear the snow.
How to operate the machine.
1 Check the distance and direction of the ex-
pelled snow.
2 Move the snow thrower forward slowly.
7 5

STOPPING

To stop the machine, proceed as follows:
• Release the starter switch (1:C).
7 6

OPERATING TIPS

1 Clear away the snow immediately after snow-
fall.
2 Go over the cleared areas again to remove
any residual snow.
3 If possible expel snow in a downwind direc-
tion.
4 For safety and to prevent damage to the
snow thrower, keep the area to be cleared
free of stones, toys and other foreign objects.
5 The effectiveness of the snow thrower de-
pends on the thickness and density of the
snow. Learn how the snow thrower works in
different snow conditions.

7 6 1 Dry and normal snow

Snow up to 15 cm deep can be removed quickly
and easily by clearing at an even speed. Plan for
downwind discharge of the snow.
(Translation of the Original Instructions)