Sensor Cables - MICRO-EPSILON NLS3181 Betriebsanleitung

Installation and Assembly
4.7
Do not kink the cables.
The minimum bending radius is 10 mm.
Lay the cable such that no sharp-edged or heavy objects can affect
the cable sheath.
Make the connection between the sensor and controller using the in-
tegral sensor cable, the transition board and the sensor cable C3/1.
Connect the sensor cable to the controller. Check the plugged con-
nections for firm seating.
The integral sensor cable has a length of 0.25 m. The sensor cable exten-
sion C3/1 has a length up to 6 m.
The cables of one type are tuned to the same capacitance at the factory.
This may result in deviations in length of +15 % in relation to the nominal
length.
i
The tuned cables may not be shortened because this changes the
capacity and the adjustment of the measuring system! The thicker
cable end must be connected with the controller.
NLS3181

Sensor Cables

To controller
10 (.39)
From sensor
Fig. 7 Transition board di-
mensions, dimensions in mm
(inches)
Height connector with board
11 mm
Page 45