Stopping Operation - Comet FDX Xtreme Bedienungs- Und Wartungsanleitung

• Connect the lance hose (21), (22) or (47) to the spray gun (19) depending on the type of high pressure
cleaner you have. Operation H in Fig. 8.
• Ensure that the nozzle holder head (24) or device (26) is not in the detergent dispensing position (see
"o
also the
peratIon wIth detergent
NOTE: as neither the FDX2 10/150 nor the FDX Xtreme have the possibility of suctioning detergent
this check is superfluous.
• Start the engine, referring to the relevant operating and maintenance manual.
• Open the water supply tap, if any.
• Press the spray gun lever (33) checking that the nozzle spray is uniform and there are no drips.
• If necessary regulate the pressure by way of the pressure regulating knob (17) (not for FDX2 10/150).
Turn it clockwise to increase pressure, anticlockwise to reduce it. You can see the pressure on the
pressure indicator (18).
• It is also possible to adjust the head (48) jet angle of the FDX2 10/150 model from fan to concentrated
(see Fig. 7).
CAUTION
• Before expecting maximum performance of the high pressure cleaner it is good practice to warm
the engine up for a couple of minutes.
The recommended detergents are more than 90% biodegradable. On how to use the detergent please
refer to the instructions given on the detergent label.
FDX2 10/150
• Fill the bottle (55) with the detergent chosen.
• Adjust detergent suction capacity as follows:
- remove the rod (54) from the foam lance (53);
- match notch L of the rod (54) with one of the numbers inside the lance (53)
(1: minimum suction, 6: maximum suction);
- put the rod (54) back in the lance (53).
• Fit the bottle (55) into the lance (53).
• Stop the engine, referring to the relevant operating and maintenance manual and connect the lance (53)
to the spray gun (19).
• Start the engine, referring to the relevant operating and maintenance manual and operate the lever (33)
(detergent mixing and suction are automatic as the water passes through).
All the other models
• Put the hose (31) in the external tank which has already been prepared with detergent to the strength
required: in this case too, follow the indications given for the dosage on the detergent pack label.
• Turn the nozzle holder head (24) or the device (26) as schematized in Fig. 7-a and then operate the
spray gun lever (33) and start dispensing detergent.
• Release the lever (33) and turn the nozzle holder head (24) or the device (26) as schematized in Fig. 7-b
to stop dispensing detergent and return to high pressure operation.
NOTE: neither the FDX2 10/150 nor the FDX Xtreme have the possibility of suctioning detergent.
• When the spray gun lever (33) is released it stops the high pressure jet and the machine goes to the
bypass mode.
• Pressing the spray gun lever (33) again the high pressure jet starts again.
30
STANDARD OPERATION (HIGH PRESSURE)
" paragraph).
OPERATION WITH DETERGENT

STOPPING OPERATION