Operation - Comet KA Classic Serie Bedienungs- Und Wartungsanleitung

5 Operation

WARNING
• The high pressure cleaner must be used with care and attention. It is your responsibility to make sure
that any infrequent users have read these instructions and are acquainted with the operation of the high-
pressure cleaner; otherwise do not allow others to use the high pressure cleaner. High-pressure cleaners
must not be used by children or by unauthorised personnel.
• Comply with the safety warnings in the operating and maintenance instructions of any optional accessories
to be used.
• Do not use the high pressure cleaner if:
- the power supply cable or other important parts such as the high pressure pipe, the safety devices, the
cleaner gun and the lance are damaged;
- the high pressure cleaner has been tipped over or has been bumped;
- there are obvious leaks of water.
In these circumstances, the high-pressure cleaner should be tested by a Skilled Technician.
• It is especially important to pay great attention when the high pressure cleaner is used in areas where
there are moving vehicles as these can crush or damage the power supply cable, the high pressure pipe,
the cleaner gun etc.
• During operation, never leave the high-pressure cleaner unattended and make sure it is out of children's
reach. Pay particular attention when using it in kindergartens, nursing homes and old people's homes,
as unsupervised children, elderly people and disabled people may be present in such places.
• Before using the high-pressure cleaner, make sure it is in a dry place and that it is in a flat and stable
position in order to avoid accidents and prevent it from falling over.
• Before moving the high-pressure cleaner, follow the instructions in the "Switching off " section.
• Before starting the high-pressure cleaner, put on clothing which guarantees adequate protection against
the possibility of incorrect manoeuvres of the jet of pressurised water. Do not operate the high-pressure
cleaner near people unless they are also wearing protective clothing.
• High-pressure jets of water can be dangerous if they are not used properly. Do not point the jet in the
direction of people, animals, and energized electrical appliances or towards the high-pressure cleaner itself.
• Hold the cleaner gun firmly during use: when operating the lever (33), the operator is subjected to the
backlash of the high pressure. The power of this recoil is indicated in the table of technical specifications
(recoil is expressed in N, where 1 N = 0.1 kg).
• Do not point the jet towards oneself or other people in order to clean off clothing or footwear.
• Vehicle tyres must be cleaned at a distance of at least 50cm to safeguard them from being damaged by
the high-pressure jet. The first evidence of damage to a tyre is a change in colour.
• Do not point the high-pressure jet towards materials, which contain asbestos or other harmful substances.
• Do not use the high-pressure cleaner in the rain.
• Pay particular attention to the instructions in the "Controls and connection to the mains electricity
supply" section.
• Pay particular attention to the instructions in the "Use with detergents" section.
• When the high-pressure cleaner is not in use, do not leave its plug in the power outlet and disconnect it
before any activity. More precisely, make sure that the mains switch (1) is in position '0', remove the plug
from the power outlet, press the lever (33) on the cleaner gun to eliminate any remaining pressure and
bring the safety catch in its locked position (32) (Fig. 2 – position S):
- before leaving the high power cleaner unattended, even for only a short time;
- before topping up the detergent;
- after use;
• In addition, wait until the high pressure cleaner has completely cooled down before cleaning or
maintenance.
• During use, do not lock the lever (33) on the cleaner gun in the open position.
• Do not remove the plug from the power outlet by pulling on the power supply cable.
• Do not put any reducers or adaptors between the electric plug and the power outlet.
• Keep the power supply cable, any extension cords, the plugs and the outlets dry. Do not touch them with
wet hands.
• Should the power supply cable be damaged, contact a Qualified Eletrician for its replacement.
• Do not cover the high pressure cleaner during operation and do not place it where there is inadequate
ventilation.
• When the high pressure cleaner is used in enclosed spaces, make sure that there is adequate ventilation.
24