Application - HBM TB1A Montageanleitung

3

Application

TB1A
Transducers measure static and dynamic torques in
non‐turning mode. The nominal torques fall within the
range 100 N⋅m to 10 kN⋅m.
Transfer torque transducer
The main applications are torque transfer, for example,
when calibrating reference transducers in test and
calibration machines and comparisons of the reference
normals of various calibration laboratories.
In the case of transfer transducers, a high degree of
comparability is important, as when relaying torque, this
provides a gage for various observers, test conditions,
laboratories and the installation and time situation. So for
relay, the same installation conditions should be created
as for calibration in the reference normal, or relevant
adapters (for recommendations, see Page 22f) should be
included in the calibration.
Reference torque transducer
Reference torque transducers are mounted in a
calibration device and then the entire calibration machine
is qualified or certified by means of transfer torque
transducers, for example. The precise sensitivity of the
transducer is thus less important.
General torque measurements in non‐turning mode
Because of the high mechanical loading capacity, the
permissible vibration bandwidth of 160 %
(10 kN⋅m = 120 %) of nominal torque and the compact
design, the transducers are also eminently suitable for
use in testing machines for component testing (rotary
alternating stress) or as reaction torque transducers, for
example in agitators with direct drive motor or gearbox
connection.
A0162-8.0 HBM: public
Application
9