Mounting
TB1A
22
As an alternative to shaft stubs, you can also use an
additional adaptation flange that is mounted on the
sensor side and is included in the measurement (see
Fig. 5.6).
D
L u
On
2
Fig. 5.6
Additional adaptation flange for transfer transducers
To make it easy to install the gaging flange with the
adaptation flange, we recommend the following flange
design:
S
Provide clearance bores on the reverse of the flange
to correspond to the bore pattern of the TB1A. The
relative position of the clearance bores should
correspond to the relative position of the tapped holes
of the TB1A.
A0162-8.0 HBM: public
L
Adaptation flange
Z
D
On
TB1A