Prior To Commissioning - diversey Taski swingo 2100 µicro Anleitung

After charging
Attention:
Switch off the charger before disconnect-
ing the batteries (only for external char-
gers).
Disconnecting the charger while it is still
switched on may result in an explosion in
the battery compartment.
• Stow away the power cord for (optional) on-board chargers
in the provided compartment.
• Store the charging cable in a dry place where it is protected
against damage.
Attention:
Charging cables transfer high currents. Do
not use the charger if there are any signs
of damage to the plug, cable or device
connection.
Maintenance and care of open (wet-cell) batteries
Notice:
The care for maintenance-free batteries is
limited to the compliance with the correct
charging processes and correct adjust-
ment of the charging curve.
Open battery compartment for maintenance
• The machine must be switched off.
• Remove the driver seat from the seat
hood and place it on the floor.
In this way you prevent the driver
seat from falling down and thereby
prevent injuring people.
• Unlock the battery compartment with
the delivered key.
• Remove the seat hood and carefully
place it on the floor.
Now the battery can be maintained
according to the manufacturer's noti
fication.

Prior to commissioning

Parking brake
Activation:
• The parking brake is automatically unlocked by the elec-
tronics when actuating the gas pedal.
Notice:
When the machine is standing still the
parking brake is always activated. This is
regardless of whether the machine is
switched on or off.
Release:
Notice:
The driver seat is equipped with a seat
switch (presence detection). This seat
switch is actuated when the driver seat is
occupied by the operating personnel.
The machine can only be operated when
the seat switch is actuated.
Emergency stop:
• If the steering or voltage supply fails,
the parking brake can be released by
hand. To this end, the unlocking lever
must be permanently pulled. The le-
ver is situated at the left rear wheel.
Check parking brake and emergency stop
Attention:
The parking brake and emergency stop
button are important safety elements.
Therefore, their function must be checked
regularly in short time intervals, before us-
ing the machine.
• Switch the machine on.
• Press the driving switch while keeping the steering wheel
straight. The machine will start to move straight ahead.
• Now press the emergency stop.
Notice:
-
The machine must abruptly brake to a
complete stop, and drive straight ahead
without steering correction.
Caution:
If one of these functions is not available,
the machine must be decommissioned un-
til professional repair by an authorized
TASKI service partner.
EN
95