End Of Operation - diversey Taski swingo 2100 µicro Anleitung

Replenishing cleaning solvent
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling sound of the pump indicates that
the fresh water tank is empty.
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 97.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
Empty recovery tank
Recovery tank full:
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 102.

End of operation

Manual process
• Press the Brush drive ON/OFF but-
ton.
• Continue to drive a few meters.
Notice:
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF but-
ton.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the Suction unit ON/OFF but-
ton.
The display lights up and the squee
gee is automatically lifted.
The suction engine continues run
ning for 15 seconds to prevent drip
ping.
Automatic process
• Press the Program ON/OFF button.
The cleaning solution supply is
stopped.
The brush unit is stopped and lifted.
After 30 seconds, the squeegee is
lifted.
The suction motor is still on for 15
seconds until it is automatically
switched off.
Removing and cleaning the squeegee
• The machine must be switched off.
• Press the spring lock [1] together and
2
remove the suction hose [2].
1
• Compress the position locks. The
suction nozzle is released and can
be removed from the suction nozzle
holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
EN
-
-
-
101