Compatibility With Third; Led Lights; Heart Rate Monitor; Power Sensor Calibration - Elite Drivo Handbuch

EN

COMPATIBILITY WITH THIRD

PARTY SOFTWARE / APP /
DEVICES
Drivo includes
My E-Training software. We suggest using this as
it's complete and features numerous options for
cyclist needs.
Thanks using standard protocols, Drivo is also
compatible with all other software / app / devi-
ces that are compatible with Drivo's standards.
Particularly, when the software / app / device is
compatible with the ANT+™ FE-C and Bluetooth
Fitness Machine profile, it will be possible to have
total interaction between Drivo and these devi-
ces.
If, however the software / app / device is compa-
tible with one or more protocols other than Drivo,
it will be possible to display training data but not
to adjust resistance.
The list of software / app / devices compatible
with the various ANT+™ protocols can be found
on the www.thisisant.com/directory

LED LIGHTS

Drivo transmits speed, cadence and power data
via the ANT+™ and Bluetooth Smart protocols.
There are 3 LED lights on the motherboard, di-
splaying power supply status, motherboard sta-
tus and the protocol being used.
The LED lights come in 3 colors with the following
meanings:
Red = status of hometrainer power supply
• Off = Drivo is not receiving power or has the
entered sleep mode
• On = Drivo is powered up.
Green = Drivo is connected via the ANT+™ pro-
tocol.
• Blinking = Drivo is awaiting connection.
• On = Drivo is transmitting data via the ANT+™
protocol.
Blue = Drivo is connected via the Bluetooth
Smart protocol.
• Blinking = Drivo is awaiting connection.
• On = Drivo is transmitting data via the Bluetooth
Smart protocol.

HEART RATE MONITOR

Drivo does not feature an integrated heart rate
monitor receiver; heart rate value is sent to the
heart rate monitor via the device connected to
22
a lifetime subscription
Drivo.
The heart rate value is picked up by the dongle
in the PC or the mobile device (smartphones/
tablets) and then displayed on screen. Only
ANT+™ heart rate monitors are compatible with
Real software for Drivo. When using the My
to
E-Training app, confirm that ANT+™ or Bluetooth
Smart smartphone protocols are compatible with
the smartphone.

POWER SENSOR CALIBRATION

Drivo can calibrate the internal power measure-
ment system, which clears the system settings
in order to always obtain accurate power values.
The procedure is simple and involves only loa-
ding a small function into the Real software and
in the My E-Training app.
This is accomplished by pedalling and increasing
speed until you reach a certain indicated value.
Remember to stop pedalling at the system
prompt.
After a few seconds the system will indicate that
the calibration process was successful.
This value is then stored in the Drivo's memory,
and accurate power data will be received from
every connected device, including non-Elite third
party software / app / devices.

CADENCE SENSOR

The Drivo uses an innovative "sensorless" system
that utilizes a sophisticated calculation based on
speed to track pedal cadence.
When maintaining a high pedal cadence at low
resistance levels, there may occasionally be a
slight inaccuracy in the cadence value since it is
the result of calculation and not direct monitoring.
This occurs especially with fast pedalling and low
resistance.
If the precision of the "sensorless" system is not
sufficient, it is possible to utilize the included wi-
red sensor.
For installation on the bike, follow the instructions
on the enclosed manual.
To activate the cadence detection via the sensor,
connect the sensor to the Drivo before starting
up the hometrainer. Some software allows the
use of wireless sensors connected directly to the
app/software/device. In this case, please consult
the specifications of the software / app / device
to verify its compatibility with wireless cadence
sensors.