Compliance With Standards; Trademarks; Supplements To The Manual; Related Documents - Stertil koni ST 1075-FWF Bedienungsanleitung

1.8

Compliance with standards

The vehicle lift has been tested, certified and found to comply with:
 the 'Machinery directive' 2006/42/EC
EN 61508 (SIL2), EN 1493, NEN-EN-ISO 13489-1, NEN-EN-ISO 13850, EN
60204-1,
 1999/5/EC R&TTE Directive,
EN 300 220-2, EN300 330-2
 the Low Voltage Directive EN60950-1, IEC60335-2-29,
 the EMC Directive 2004/108/EC,
EN 301 489-01, EN 301 489-02, EN 61000 3-2, EN 61000 3-3
The product also complies with all applicable CE-directives and therefore bears a
CE plate.
1.9

Trademarks

All trademarks stated in this manual are registered trademarks of their suppliers.
The instructions in this manual do not take into account different national regulations
and laws. When operating the machine, it is the sole responsibility of the user to
make sure that all applicable local laws and regulations are obeyed.
1.10

Supplements to the manual

If you receive any supplements to the manual from Stertil, these must be inserted
into the manual immediately.
1.11

Related documents

This manual is part of the documentation set for the vehicle lift. This set consists of
the following documents:
 Operator Manual,
This manual contains all required information for the operation of the vehicle lift.
This manual details also operator related maintenance.
 Service and Parts Manual,
This manual describes the procedures required for a proper installation and
details preventive and corrective maintenance to be carried out by a certified
service engineer. This manual contains also all the relevant system engineering
drawings as well as the lists of spare parts of the lifting system.
Operation Manual (Version A) 8 Wireless