Safety Measures - Stertil koni ST 1075-FWF Bedienungsanleitung

2.3.5

Safety measures

For safe operation, installation and maintenance of the vehicle lifts, the following
safety measures must be observed:
 use the vehicle lift exclusively for lifting vehicles, and for no other purpose,
 install the vehicle lift in such a way that a safe working environment is created, at
the same time providing escape routes for emergencies (minimum 600 mm free
passage),
 to reduce the risk of electric shock, avoid working on wet surfaces and do not
expose the lifting system to rain,
 do not use the lifting system outdoors when wind speeds exceed the maximum
stated in section Outdoor use (on page 47) of the Operator Manual,
 do not leave vehicles unattended in the raised position when the lifting system is
used outdoors; the wind speed might increase and exceed the prescribed safe
maximum,
 allow only authorized persons to operate the vehicle lift;
these persons must always be fully conversant with the instructions for use of the
vehicle lift,
 whenever operating the vehicle lift, ensure that there are no persons or objects
present in the work area of the vehicle lift (including vehicle),
 watch the vehicle closely whenever the vehicle lift is being raised or lowered,
d
Warning
Obstacles (trestles, etc.) under the vehicle can cause hazardous situations when
lowering. Placing an excessively tall vehicle on the vehicle lift can also cause
hazardous situations to arise.
 never stand on or under the vehicle (with load) while the vehicle lift is being
operated,
 always raise the vehicle lift to the first safety lock whenever someone is working
at the vehicle.
 always lower the vehicle lift into the safety lock whenever someone is working at
the vehicle,
 never climb onto the vehicle lift or the vehicle when they are raised,
 use the lifting system only as described in this manual and only use parts that are
recommended by the manufacturer,
 in the event of a malfunction or when work is finished, always set the vehicle lift to
the bottom position and shut off the power using the main switch; do this by
turning the main switch to the 0 position, then pull the main plug,
Operation Manual (Version A) 16 Wireless