Help; Traverse Beam (Option) - Stertil koni ST 1075-FWF Bedienungsanleitung

The data should be placed on the USB memory stick as follows:
 There must be a folder called "Factory" on the USB memory stick. This contains
the following files:
- Factory.bmp:
manufacturer's logo.
24-bit color,
dimensions limited to 378 pixels horizontally and 56 pixels vertically.
- Factory.txt:
manufacturer's contact details (Stertil Koni NL/USA).
Example:
Stertil-Koni
Westkern 3
9288 CA KOOTSTERTILLE (NL)
Tel. +31(0)512-334441
service@stertil-koni.com
www.stertil-koni.com
 There must be a folder called "Service" on the USB memory stick. This folder
contains the following files:
- ServiceLogo378x56Max.bmp,
- Service.txt:
contact details of the service organization.
n
Note
Prepare a memory stick containing logos and contact details, and then transfer the
data to the column lift by performing a "restore". Enter the users and make the other
settings. If you now make a backup, the USB memory stick will then contain all the
data (users, settings, logos and contact details). These data can now be copied onto
the other column lifts using a "restore".
4.8

Help

The [Guide] button lets you access and extensive help menu.
4.9

Traverse beam (option)

For the lifting and lowering of trailers on a set of mobile lifting columns, a special
Stertil-Koni traverse beam is available.
For the operating procedures and safety precautions of the traverse beam, see
section Traverse beam (on page 69).
Operation Manual (Version A) 46 Wireless