Installation And Setting - Meister MOF1300-1 Originalbetriebsanleitung

5458020-Oberfraese_man 07.11.14 07:20 Seite 64
Mains voltage, mains
frequency and power
consumption
Idling speed
Shank diameter of the router
heads
Caution! Operate only if
ensured that the dust-
extraction device is
connected!
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
„Tested Safety" voluntary
quality mark
The housing is double-
insulated
CE Mark (conformity to
European safety standards)
Manufacturer's address
7 – Installation and setting
ATTENTION! Always unplug from
power supply before mounting
and adjusting!
Fit collet and router head
Risk of injury! Always unplug
from mains before changing bits!
Always wear safety gloves when
handling router heads!
64
Place router on its side.
Fig. 7-1 simplified diagram without
router bas
Turn the router axle (1) by hand, at the
same time pressing the lock button (2).
As soon as it engages: Hold it down
firmly and using an open-ended
spanner, screw off the router chuck (3).
Fig. 7-2: Select a suitable collet (4) for
the router head used.
For router heads with
6 mm shank: small inner diameter
8 mm shank: large inner diameter.
Insert collet (4) and screw router chuck (3)
on again loosely by hand.
Fig. 7-3: Insert the shaft of the router
head (5) into the collet (4) by approx.
shaft length.
Fig. 7-4: Turn the router axle (1)
clockwise by hand, at the same time
pressing the lock button (2) (2). As soon
as it engages: Hold it down firmly and
using an open-ended spanner, tighten
the router chuck (3) firmly.
Set depth stop
It is recommended to set
the depth stop, if the
router head is to be
plunged into the surface
of the workpiece to a
specified depth.
Fitting router head.
Move depth limiter to zero setting (see
Fig. 7-9).
Place router on the workpiece.
3
/
4